Infinity TSS-SAT500 User Manual download pdf (Page 4)

TSS-SAT500

WALL-MOUNTING

The TSS-SAT500 satellite is designed to be mounted on the wall.

There is a wall bracket included.The speaker bracket will require

four 1-1/2" #10 wood screws; each screw should be fastened to a

wall stud. If a wall stud is unavailable, install an anchor appropriate

for a 1-1/2"#10 screw.

NOTE: The customer is responsible for the correct selection and use

of mounting hardware (available through hardware stores) that will

ensure the proper and safe wall-mounting of the speakers.

Step 1. Detach shelf stand by removing screw in rear of speaker.

Step 2. Mark the positions on the wall where you would like to place

the mounting screws.

Step 3. Place bracket against the wall and fasten four 1-1/2" #10

wood screws through the bracket’s screw holes into the wall. If a

wall stud is not available, use an appropriate anchor.

Step 4. Unscrew round collar (C) from bracket (A).

Step 5. Screw the ball and shaft assembly (B) to 1/4"-20 insert on

rear of speaker. Back out 1/2 of a turn and tighten nut against the

speaker.

Step 6.Attach speaker wire as shown on page 5.

Step 7. Drop round collar (C) over ball and shaft assembly (B) that

is mounted to the speaker with the finished side of the collar facing

the rear of the speaker.

Step 8. Carefully push the ball straight into the socket mounted on

the wall, angle the speaker as desired and tighten the collar using

the enclosed metal bar.

Figure 3. Bracket on wall.

Metal Bar

1 2 3 4 5 6 7 8

No comments

Infinity TSS-SAT500 User Manual Page 4