Infinity IL60 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 41
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
IL60 L/R
16
Test Set Up and Procedure
SYSTEM AURAL SWEEP TEST
Equipment needed:
• Function/signal generator/sweep generator
• Integrated Amplifier
• Multimeter
• Speaker cables
General Unit Function (UUT = Unit Under Test)
Switches on the amplifier faceplate:
Sub Input to “Line Level”
Low Pass Filter to OFF
Bass Optimization system to OFF
1. From the signal generator, connect one line level (RCA) cable to the IL60 Line Level Input jack on the UUT.
2. On the front of the unit, turn the LEVEL control full counterclockwise (1).
3. Turn on generator, adjust to 100mV, 40 Hz.
4. Plug in UUT; turn the power switch ON. LED should be Red. Turn LEVEL control full clockwise (10).
5. LED should now be Green; immediate bass response should be heard and felt from rear port tube opening.
6. Turn off generator, turn LEVEL control fully counterclockwise (1), disconnect RCA cable.
7. Connect one pair of speaker cables to Speaker Level input terminal on UUT. Cables should be connected to
an integrated amplifier fed by the signal generator.
8. Switch Sub Input on the amplifier faceplate to “Speaker”.
9. Turn on generator and adjust so that speaker level input at the amplifier is 1.5V, 50 Hz. Turn LEVEL control
full clockwise (10).
10. Green LED should light, immediate bass response should be heard and felt from the port tube opening.
Sweep Function
1. Follow steps 7-10 above, using a sweep generator as a signal source.
2. Sweep generator from 20Hz to 20kHz. Listen to the cabinet and drivers for any rattles, clicks, buzzes or any
other noises. If any unusual noises are heard, remove woofer and test.
Driver Function (Woofer)
1. Remove woofer from cabinet; detach + and - wire clips.
2. Check DC resistance of woofer; it should be 3.4 ohms ±10%.
3. Connect a pair of speaker cables to driver terminals. Cables should be connected to an integrated amplifier
fed by a signal generator. Turn on generator and adjust so that speaker level output is 5.0V.
4. Sweep generator from 20Hz to 1kHz. Listen to driver for any rubbing, buzzing, or other unusual noises.
SIGNAL
GENERATOR
AMPLIFIER
AC VOLT
METER (10V)
IL60
UNDER TEST
OUTPUT FROM GENERATOR/AMPLIFIER
O
+
®
00345
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Comments to this Manuals

No comments